Skip to main content

Spa Parts Made Simple

Pumps, heaters, control boards, and replacement parts — without the confusion.

Shop Spa Parts
✔️ Real OEM & compatible spa parts
✔️ Fast shipping from the USA
✔️ Knowledgeable support when you need it
✔️ Trusted by spa owners since 2015

Not sure which part fits your spa?

We help you compare possible replacement parts using your model, part number and measurements.

  1. Find your spa model
  2. Match the part number
  3. Order with confidence
Get Help Finding a Part

SpaShopper makes it easy to find quality hot tub and spa replacement parts without the frustration. From spa pumps and heaters to control boards, jets, filters, and plumbing components, we stock parts that fit a wide range of popular spa brands. Whether you’re fixing a heating issue, replacing a worn pump, or upgrading aging components, SpaShopper helps you get your spa running again quickly and confidently.

Aqua-Flo XP2/XP2e 2.5HP Wet End Assembly - 2"x2" 48 Frame 11.0A/230V Complete Kit

SpaShopper

MSRP: $158.95
$134.95
(You save $24.00 )
(No reviews yet) Write a Review
SKU:
HTP34-402-1208
Adding to cart… The item has been added

Please Note: Only One Threaded Drain/Bleeder Port

The original Aqua-Flo XP2/XP2e wet end faceplate had 3 threaded drain/bleeder holes. Newer wet ends now come with only one threaded port. The other holes are molded into the plastic but do not have threads cut into them. If your installation needs more than one connection, you will need to tap the extra hole(s).

The Aqua-Flo XP2e pump wet end uses 1/4"-18 NPSM straight pipe threads for the drain plug opening. To add the threads, you will need a 1/4"-18 NPSM straight pipe thread tap. Carefully cut the threads by hand, keeping the tap straight and backing it out periodically to remove plastic shavings. Do not overtighten the drain plug when installing it.

Important: Use an NPSM straight-thread tap, not an NPT tapered-thread tap. The original drain plug uses an O-ring to create the seal.

This is a fully assembled 2.5HP Aqua-Flo wet end designed for XP2 pump systems, featuring 2" x 2" plumbing connections (approximately 3" measured across threads) with side discharge configuration. Engineered specifically for 48 frame motors rated at approximately 11.0 Amps on high speed at 230V operation. Not compatible with 115V motors. Works with both single speed and dual speed motor configurations.

The discharge orientation can be adjusted by rotating the wet end 90 degrees to suit your installation requirements. This complete assembly arrives ready to install and includes all essential components: volute housing, mechanical seal, impeller, wear ring, suction cover with o-ring, drain plug with o-ring, and mounting screws for the suction cover.

Optional Barb Fittings for Wet End Face Connections:
For installations requiring small hose connections to the front face of the wet end, consider these barb adapter options at 3/8"b x 1/4"mpt sizing (compatible with Aqua-Flo and CMP designs). These fittings work best when sealed with silicone rather than standard pipe tape.

Important Selection Guidelines: Always select wet end horsepower based on your motor's amperage rating. Reference: 48 frame motors measure approximately 5 1/2" across the body, feature 1/4" hex heads on through-bolts, and have roughly 5 3/16" spacing between through-bolts (measured diagonally). By comparison, 56 frame motors measure about 6 1/4" across with 5/16" hex bolt heads and approximately 5 7/8" through-bolt spacing in cross pattern.