Please Note: Only One Threaded Drain/Bleeder Port
The original Aqua-Flo XP2/XP2e wet end faceplate had 3 threaded drain/bleeder holes. Newer wet ends now come with only one threaded port. The other holes are molded into the plastic but do not have threads cut into them. If your installation needs more than one connection, you will need to tap the extra hole(s).
The Aqua-Flo XP2e pump wet end uses 1/4"-18 NPSM straight pipe threads for the drain plug opening. To add the threads, you will need a 1/4"-18 NPSM straight pipe thread tap. Carefully cut the threads by hand, keeping the tap straight and backing it out periodically to remove plastic shavings. Do not overtighten the drain plug when installing it.
Important: Use an NPSM straight-thread tap, not an NPT tapered-thread tap. The original drain plug uses an O-ring to create the seal.
This component is a Complete 1.5HP Aqua-Flo 2" x 2" (approximately 3" across threads) side discharge 48 frame wet end assembly designed for XP2 pump systems. This wet end assembly pairs with a 48 frame motor rated at approximately 9.0 Amps on High Speed for 230V motors or 13.0 Amps High Speed for 115V motors using 1/4" thru-bolt configuration. Compatible with both single and dual speed motors. Features 90-degree rotational capability for flexible discharge positioning. This full wet end kit contains: volute housing, seal assembly, impeller, wear ring, suction cover, suction cover o-ring, drain plug, drain plug o-ring and all suction cover mounting screws.
For installations requiring a barb connection on the wet end face for small hose attachment, consider these barb adapter options with or without sealant. Silicon sealant is recommended for these fittings as pipe tape does not provide adequate sealing:
Barb Adapter, 3/8"b x 1/4"mpt, Pump Wet End Face fits Aqua-Flo & CMP
Barb Adapter, 3/8"b x 1/4"mpt, With Silicon Kit Pump Wet End Face fits Aqua-Flo & CMP
Important: Always select HP rating based on your motor's amperage reading per the reference chart below. A 48 frame motor typically measures approximately 5 1/2" across the motor body, features 1/4" thru-bolt heads, and measures roughly 5 3/16" between thru-bolts in cross pattern. A 56 frame motor measures approximately 6 1/4" across the motor body, features 5/16" thru-bolt heads, and measures roughly 5 7/8" between thru-bolts in cross pattern.
