Genuine 1.0 Horsepower Impeller for Aqua-Flo XP2 and FMXP2 Wet End Systems
This replacement impeller is engineered for Aqua-Flo 48 or 56 frame wet end configurations and features precise specifications: 2 1/8 inch eye diameter, 1/4 inch vane width, and 3 7/8 inch outer diameter. Part numbers 91694110 and 5121-39.
Motor Compatibility & Electrical Requirements:
- 1.0HP motors operating at 230V draw approximately 8.0 amps on high speed
- 1.0HP motors operating at 115V draw approximately 12.0 amps on high speed
Installation Details:
The impeller installs between the face plate and volute housing of your Aqua-Flo XP2 or FMXP2 wet end assembly. We strongly recommend replacing your PS-200 seal simultaneously with impeller replacement for optimal performance and longevity.
Frame Identification Guide:
- 48 Frame: Motor through-bolts measure 3 5/8 inches between centers (5 3/16 inches in X pattern) with 1/4 inch bolt heads
- 56 Frame: Motor through-bolts measure 4 1/8 inches between centers (5 3/4 inches in X pattern) with 5/16 inch bolt heads
Critical Sizing Warning:
Always match your existing impeller horsepower rating exactly. Installing an oversized impeller will cause motor overheating, excessive amperage draw, and potential equipment failure. Verify your motor's amp rating on the label to confirm proper horsepower before ordering.
This component requires the PS-200 seal for proper installation and operation. All sales are final on this precision-manufactured part, so please verify compatibility before purchasing.
