This Jet Pump is found from the factory Rarely in hot tubs so be sure you are choosing the correct one.
This pump is a 56 frame XP2e called 5.0HP I would call it a 4.5HP 230V Side Discharge wet end with a 2 1/2" suction side which measures about 3 5/8" edge to edge and 2" pressure side which measures about 3" edge to edge. The amperage is 15 Amps on High Speed and 4.8 Amps on Low making it a 4.5 Horse Power Pump..
Note: You need to be sure of your voltage by checking one of two things. Either the label on the pump which will say either 115V or 230V or you can look to see where the white wire from the pump is located in the pack if you can't see the label. If the white wire is on the red leg or #2 leg the pump is 230V if it is on the Neutral or the White AC leg. Always turn the breaker to the hot tub off before doing any of these checks.
If You need a pump Bleeder Barb Click here: Barb Adapter, 3/8"b x 1/4"mpt, With Silicon Kit Pump Wet End Face fits Aqua-Flo & CMP
Spa Pump Features:
- Fine tuned impeller that moves water through the system with maximum performance
- 2 1/2" intake and 2" discharge
- 56-frame motor for added strength
- Thermally protected to extend life expectancy of motor
| Complete Pump Type | Portable Spa Pump |
| Speed | 2 Speed (2-Spd) |
| Motor Voltage | 230v |
| Drain Plug Location | 4,6,9 o`clock |
| Pump to Motor Foot Types | 9 |
| Suction Style | Center |
| Suction Connection (Physical Dimension) | 3-11/16" od |
| Suction Connection Type | Male Buttress Thread (mbt) |
| Suction Pipe Size | 2" or 2 1/2" |
| Discharge Style | Side |
| Discharge Connection (Physical Dimension) | 3" od |
| Discharge Connection Type | Male Buttress Thread (mbt) |
| Discharge Pipe Size | 2" |
| Horsepower | 4.5HP called 5.0hp |
| Motor Frame | 56 Frame Thru-Bolt |
| Motor Amperage/Wattage | 15.0A/4.8A |
| Manufacturer | AquaFlo/Gecko |
| Pump Model | Flo-Master XP2e |
IMPORTANT MOTOR VARIATION NOTICE
Due to ongoing changes in the hot tub pump industry since COVID, motor appearance and configuration may vary, even when the part number is the same. While the pump wet end will be correct, the motor may differ in areas such as capacitor location, labeling, or housing.
If you have a specific motor requirement (clearance, capacitor position, orientation, etc.), you must contact us before ordering so we can verify availability. Do not order first and contact us after delivery due to appearance differences.
Motor variations are outside of our control and may change week to week. Appearance differences do not constitute an incorrect item if specifications are met.
