HydroQuip Temp Sensor with for use with newer HydroQuip VDS control units that have the sensor mounted in the stationary heater, rather than in the side wall of the hot tub. This sensor has a 1/4" diameter bulb and 36" cable. Plugs to the lower right edge of the circuit board, near where the topside control is plugged in.
For use with: CS6200, 9200, 6500, 7500, 8500, 9500, 9700, 6330, 9330, CS6230VDS
| Sensor Application | Spa Control |
| Sensor Type | Temperature |
| Application | Gecko / HydroQuip |
| Models | S-Class, M-Class Based Systems |
| Connector Type | 4 pin |
| Sensor Diameter | 1/4" |
| Wire Count | 2 wire |
| Wire Length | 36" |
