This Seal Kit is used ONLY in Watkins Hot Spring Caldera Wet Ends where the motor has the Vendor code of 3536. This kit features the seal and an install tool as well as silicone to install the seal with.. It is 1 39/64" Across the back of the Spring Seal part that goes into the volute or wetend back and the Ceramic & Rubber part that goes into the impeller is 1 11/32". The Hole in the ceramic part is about 3/4" and the hole in the spring side measures about 45/64".
NOTE: Search for Vendor # 3536 on the pump motor label if your has that then this kits is correct..
If yours has other Vendor numbers like 4081, 0108 or 3861 on the label click here: Watkins Pump Parts
To Install you should put silicon sealant on the back of the Metal part and gently push it into place with a 1" coupler as the push tool. Also the rubber part can use a light coat of silicon to slide it into place in the impeller.
We offer these alone, with The Professor's Silly Juice or with an Impeller in a kit so look in our store. Note: We offer this seal with the seal too and silicon, with the seal tool and silicon and bearings or the seal with the seal tool, silicon and an impeller in our store.
1000, VG-1000, USSPS1000B, 5250-106, AS-1000, 071734S, PS-1000,319-3100B,waterway, executive, hiflo, hi-flo, wet end, wet end, spa wet end seal , hot tub wet end seal, 1000 seal, p-1000 seal, ps-1000 seal, p 1000 seal, ps 1000 seal
Please note: When you have a seal leaking in most cases you will need an impeller because the leak caused water to get into the metal shaft area that the impeller is screwed onto and expands and damages the impeller. We offer the impellers along with the seal in a kit in our store. Watch the video above for how to install the seal and other repairs for this pump as well.
WUA200-II,WUA300-II,WUA400-II,WUA200-I,WUA300-I,WUA400-I,LP200,LP250,LP300,LP150,WP200-II,WP250-II,WP300-II,WP200-I,wp250-I,wp300-I,wp400-I
WUA200,WUA300,WUA400,WUA200,WUA300,WUA400,LP200,LP250
